, ,

BTS7960 43A IBT 2 Motor Driver H Bridge in Pakistan


About

Model: IBT-2

  1. Input voltage: 6V-27V Maximum current:
  2. 43A Input level: 3.3-5V
  3. Control method:
  4. PWM or level Duty cycle: 0-100%

 1,250

Compare

IBT 2 BTS7960 H-Bridge Motor Driver

IBT 2 BTS7960 H-Bridge Motor Driver This driver use Infineon chips BTS7960 compose of high-power drive full H-bridge driver module with thermal over-current protection. Double H-bridge driver circuit, with a strong drive and braking, effectively isolating the microcontroller and motor driver! High-current 43A.

Electrical performance:
Model: IBT-2
Input voltage: 6V-27V
Maximum current: 43A
Input level: 3.3-5V
Control method: PWM or level
Duty cycle: 0-100%
Input port:
1.RPWM: forward level or PWM signal input, active high
2.LPWM: Reverse level or PWM signal input, active high
3.R_EN: forward drive enable input, high-level enable, low level off
4.L_EN: Reverse drive enable input, high-level enable, low level off
5.R_IS: forward drive current alarm output
6.L_IS: Reverse drive current alarm output
7.VCC: +5 V power output, 5V power supply connection with the microcontroller
8.GND: signal common low end

IBT 2 BTS7960 H-Bridge Motor Driver Features:

  • 5V isolate with MCU, and effectively protect MCU; 5V power indicator on board.
  • Voltage indication of motor driver output end; can solder heat sink.
  • Just need four lines from MCU to driver module (GND. 5V. PWM1. PWM2); isolation chip 5 V power supply (can share with MCU 5 V).en.wikipedia.org
  • Able to reverse the motor forward, two PWM input frequency up to 25kHZ; two heat flow passing through an error signal output.
  • Isolate chip 5V power supply (can be shared with the MCU 5V), can also use the on-board 5V supply; the supply voltage 5.5V to 27V.
  • A H-bridge is an electronic circuit that switches the polarity of a voltage apply to a load. These circuits are often use in robotics and other applications to allow DC motors to run forwards or backwards.[1] The name is derived from its common schematic diagram representation, with four switching elements configure as the branches of a letter “H” and the load connect as the cross-bar.Most DC-to-AC converters (power inverters), most AC/AC converters, the DC-to-DC push–pull converter, isolate DC-to-DC converter[2] most motor controllers, and many other kinds of power electronics use H bridges. In particular, a bipolar stepper motor is almost always driven by a motor controller containing two H bridges.

Based on 0 reviews

0.0 overall
0
0
0
0
0

Be the first to review “BTS7960 43A IBT 2 Motor Driver H Bridge in Pakistan”

There are no reviews yet.

You may also like…