– Size: 0.96

– Resolution: 128X64

– Viewing angle: greater than 160 degrees

– Supported platforms: for Arduino, 51 series, MSP430 series, STIM32 / 2, SCR chips

– Low power consumption: 0.04W during normal operation

– Support wide voltage: 3.3V-5V DC

– Working temperature: -30-80 degrees

– Volume: 27MM * 27MM * 4.1MM

– Driver IC: SSD1306

– Communication: IIC, only two I / O ports

– No font: The software takes word modulo

– Backlight: OLED self light Yellow , no backlight

Interface:

– VCC: 3.3-5V

– GND: Ground

– SCL: Serial Clock

– SDA: Serial Data

•  The screen is made in Taiwan, quality is much better. Compatible with MMDVM,Pi-Star, and it works with raspberry pi en.wikipedia.org
•  The IIC address can be change, it is convenient to use with different machines
•  Four square holes are easy to install, and no need a pull-up resistor on the i2c lines from an Arduino UNO
•  What You Get: 1 X 0.96 White OLED Module. PS: How to use these two Oled display modules at the same time, pls check the video for reference: